CAAS Audio는 영국 요크셔에서 설립된 회사인데, 그래서인지 디자인에서 dCS의 냄새가 납니다. 스스로 A class전문이라고 하니 출시하는 앰프는 대략 짐작이 갑니다만 실제 스펙을 보면 어라? 합니다. 초기구간만 A class고 출력이 높아지면 AB class로 구동되는 일반적인 방식입니다.

Elysian EPre II & 100 Power는 세트로 18,000파운드로 프리만은 8,000/ 파워는 모노로 개당 5,000파운드 즉 페어에 10,000파운드입니다. 요새 기기들 가격치고는 적당한 수준.



전면패널은 커스텀 아노다이지을 제공하고 있을 정도로 자신감이 있어보이지만, 뒷면을 보면 아직은 상업적으로 미완성의 느낌이 납니다. 그런것보면 역사 깊은 브랜드라는 것은 단순히 오래되었다는 것만이 아니라 그만큼의 노하우라 쌓인것이라걸 다시 일깨워 줍니다.(고스톱 쳐 딴게 아니라는 말을 점잖게 하려니 어색하군요)


– Gain: +6dB to -64dB & Mute (in 0.5dB steps).
– Freq Response: 0.3Hz to >200kHz (-3dB) DC Coupled.
– Input Impedance: 33 kohms.
– Output Impedance: 60 ohms.
– THD: < 0.01% @1kHz (0dB level, 2V RMS).
– Inputs: 2 x L/R Pair RCA, 3 x L/R Pair XLR.
– Outputs: 1 x L/R Pair RCA, 1 x L/R Pair XLR.
– “RWave” – Ultra wide bandwidth circuit topology.
– “CSD” – Open loop, BJT drive topology.
– “TZFB” – True zero feedback design (NO global feedback, NO local feedback).
– “NIDS” – Non-Intrusive DC Servo system.
– “Fastpower” – 12 bespoke, discrete analogue regulated supplies and 7 digital regulated power supplies.
– “SAM” – Switched Amplifier Modules.
– “SRVC” – 128 step relay switched resistor volume.
– DC coupled from input to output (NO capacitors).
– Triple transformer supplies for circuit isolation.
– Gain: 25.5dB (into 8ohms)
– Frequency Response: 0.8Hz to >300kHz (-3dB) DC Coupled
– Rated Output: 100W into 8ohms (1st 20W Class A), 200W into 4ohms
– Peak Output Current: >50A (10ms cycle every 200ms)
– Input Impedance: 33kohms (single ended RCA), 66kohms (balanced XLR)
– Output Impedance: 0.1ohm
– Total Harmonic Distortion: <1% @1kHz (100W into 8ohms), <0.01% @1kHz (1W, 0dBW into 8ohms)
– Transient Intermodulation: Too low to measure
– “RWave” – Ultra wide bandwidth circuit topology.
– “CSD” – Open loop, symmetric drive topology.
– “TZFB” – True zero feedback design
(NO global feedback, NO local feedback).
– “NIDS” – Non-Intrusive DC Servo system.
– “Fastpower” – 6 bespoke, discrete regulated supplies.
– “OpBias” – Optimal power bias system.
– DC coupled from input to output (NO capacitors).
– Dual transformer supplies for near perfect isolation.
– Ultra low Transient Intermodulation Distortion.
– Linear phase response with zero feedback essential for a truly perfect sound stage.